C746 Cable Extender

You may find the following links helpful in addressing this issue:

If you unable to resolve the issue, log in to http://myUR.universal-robots.com and create a new case.

C746A0 The house temperature is too low: {float} Celsius

The house temperature is below the allowed limit

Try the following actions to see which resolves the issue: (A) Increase the ambient temperature, (B) Update software, (C) Contact your local Universal Robots service provider for assistance

C746A1 The house temperature is too high: {float} Celsius

The house temperature is above the allowed limit

Try the following actions to see which resolves the issue: (A) Reduce the ambient temperature, (B) Update software, (C) Contact your local Universal Robots service provider for assistance

C746A2 The energy eater temperature is too low: {float} Celsius

The energy eater temperature is below the allowed limit

Try the following actions to see which resolves the issue: (A) Increase the ambient temperature, (B) Update software, (C) Contact your local Universal Robots service provider for assistance

C746A3 The energy eater temperature is too high: {float} Celsius

The energy eater temperature is above the allowed limit

Try the following actions to see which resolves the issue: (A) Decrease the robot accelerations and speeds, (B) Update software, (C) Reduce the ambient temperature, (D) Contact your local Universal Robots service provider for assistance

C746A4 Cable type mismatch between near and far cable extenders

The cable extenders does not have the same cable type

Try the following actions to see which resolves the issue: (A) Make sure that the robot cable extender is configured properly, (B) Update software, (C) Contact your local Universal Robots service provider for assistance

C746A5 The energy eater regulation is inactive

The energy eater regulation is not running at the expected frequency

Try the following actions to see which resolves the issue: (A) Conduct a complete rebooting sequence, (B) Update software, (C) Contact your local Universal Robots service provider for assistance

C746A7 The connected cable was not recognized

The connected cable did not have a recognized ID resistor

Try the following actions to see which resolves the issue: (A) Make sure the cable is connected properly, (B) Make sure that the cable ID resistor is connected properly to the extender board, (C) Update software, (D) Contact your local Universal Robots service provider for assistance