CB2/CB3

Description

CB2 and CB3 Control Boxes run PolyScope 5 from removable storage. CB2.0 and CB3.0 use a CF card. CB2.1 and CB3.1 use a USB drive.

You can update the installed software with a URUP file or write a full robot image to the removable storage. A full robot image erases the storage device.

Use a URUP file for a normal PolyScope 5 software update.
Write a full robot image when you replace damaged storage, recover a Control Box, or need a clean installation.

PolyScope X and Robot Tools are not supported on CB2 or CB3. Select the .img robot image that matches the Control Box and storage type. Do not use a .dmg file.

Procedures

For a normal software update, see PolyScope 5 Software Update. For USB drive requirements, see USB Update Procedure.
To select the correct CB2 or CB3 image and write it to the removable storage, see Files to Download and Installing Robot Image.
When you replace the removable storage in a CB3 Control Box, see Flashcard Replacement.