Introduction

About this document

This guide describes how to install a Universal Robots Injection Molding Machine Interface (IMMI) module on a Universal Robots e-Series control box and how to configure the Injection Molding Machine Interface (IMMI) software, to interface with an Injection Molding Machine (IMM).

What's in the box

The box contains the following parts:

IMMI module
Cables:
- EUROMAP 67 / SPI AN-146
- Ribbon cable
Ground (GND) wire:
- M6 nut
- M6 washer
Universal Robots EUROMAP 67 bypass plug
This document

Company Details

Universal Robots A/S

Energivej 51, 5260 Odense S, Denmark

+45 89 93 89 89

https://www.universal-robots.com