Introduction
About this document
This guide describes how to install a Universal Robots Injection Molding Machine Interface (IMMI) module on a Universal Robots e-Series control box and how to configure the Injection Molding Machine Interface (IMMI) software, to interface with an Injection Molding Machine (IMM).
What's in the box
The box contains the following parts:
- IMMI module
- Cables:
- EUROMAP 67 / SPI AN-146
- Ribbon cable
- Ground (GND) wire:
- M6 nut
- M6 washer
- Universal Robots EUROMAP 67 bypass plug
- This document
Company Details
Universal Robots A/S
Energivej 51, 5260 Odense S, Denmark
+45 89 93 89 89