C75 Joint encoder error

Magnetic encoder error (absolute encoder). Argument = sum of C75 errors

C75A1 Invalid decode: Readhead misalignment, ring damaged or external magnetic field present.

Try the following actions to see which resolves the issue: (A) Conduct a complete rebooting sequence, (B) Check grounding and shielding for EMC problems, (C) If this happens more than twice, replace joint

C75A2 Speed reading is not valid

Try the following actions to see which resolves the issue: (A) Conduct a complete rebooting sequence, (B) If this happens more than twice, replace joint

C75A4 System error=malfunction or inconsistent calibration detected

Try the following actions to see which resolves the issue: (A) Conduct a complete rebooting sequence, (B) If this happens more than twice, replace joint

C75A8 Supply voltage is out of range

C75A16 Temperature is out of range

C75A32 Signal lost =Misaligned readhead or damaged ring

Try the following actions to see which resolves the issue: (A) Conduct a complete rebooting sequence, (B) Check grounding and shielding for EMC problems, (C) If this happens more than twice, replace joint

C75A64 Signal low =Too far from magnetic ring

Try the following actions to see which resolves the issue: (A) Conduct a complete rebooting sequence, (B) Check grounding and shielding for EMC problems, (C) If this happens more than twice, replace joint

C75A128 Signal saturation =Too close to magnetic ring

Try the following actions to see which resolves the issue: (A) Conduct a complete rebooting sequence, (B) Check grounding and shielding for EMC problems, (C) If this happens more than twice, replace joint

C75A200 Position from joint encoder does not change while motor is running

If you unable to resolve the issue, login to http://myUR.universal-robots.com and create a new case.