C305 Robot Power Control

You may find the following links helpful in addressing this issue:

If you unable to resolve the issue, log in to http://myUR.universal-robots.com and create a new case.

C305A0 Critical error

A critical error in power control module

Try the following actions to see which resolves the issue: (A) Conduct a complete rebooting sequence, (B) Update software, (C) Contact your local Universal Robots service provider for assistance

C305A1 Power supply voltage too low

Try the following actions to see which resolves the issue: (A) Check for loose connections, (B) Conduct a complete rebooting sequence, (C) Update software, (D) Contact your local Universal Robots service provider for assistance

C305A2 Robot cable not connected

Try the following actions to see which resolves the issue: (A) Make sure the cable between Control Box and Robot Arm is correctly connected and it has no damage, (B) Check for loose connections, (C) Conduct a complete rebooting sequence, (D) Update software, (E) Contact your local Universal Robots service provider for assistance

C305A3 Short circuit in Robot detected or the wrong Robot is connected to the Control Box.

Try the following actions to see which resolves the issue: (A) Check for loose connections, (B) Make sure the cable between Control Box and Robot Arm is correctly connected and it has no damage, (C) Conduct a complete rebooting sequence, (D) Update software, (E) Contact your local Universal Robots service provider for assistance

C305A4 Robot voltage rising slower than expected

Try the following actions to see which resolves the issue: (A) Verify the power supply, (B) Verify Control Box and Robot Arm are correctly paired, (C) Contact your local Universal Robots service provider for assistance

C305A6 Power supply voltage too high: {float} V

Try the following actions to see which resolves the issue: (A) Check for loose connections, (B) Make sure the cable between Control Box and Robot Arm is correctly connected and it has no damage, (C) Conduct a complete rebooting sequence, (D) Update software, (E) Contact your local Universal Robots service provider for assistance

C305A8 The Robot Voltage is too high ({float})V when powering on the Robot

Try the following actions to see which resolves the issue: (A) Conduct a complete rebooting sequence, (B) Update software, (C) Contact your local Universal Robots service provider for assistance

C305A9 The Power State was not OFF ({unsigned}) when trying to power on the Robot

Try the following actions to see which resolves the issue: (A) Conduct a complete rebooting sequence, (B) Update software, (C) Contact your local Universal Robots service provider for assistance

C305A11 The power to the robot arm was not removed fast enough after violation

C305A12 Unexpected energy eater type

The detected energy eater type was different from the expected type. This may be due to a wrong energy eater type being installed in the control box, or that the connections to the energy eater are damaged.

Try the following actions to see which resolves the issue: (A) Conduct a complete rebooting sequence, (B) Check the connection between the control board and the energy eater, (C) Check if the correct energy eater is installed (D) Update software, (E) Contact your local Universal Robots service provider for assistance