Mounting Description

Description
Robot arm (Base)

Mounted with four 8.8 strength, 6.6mm bolts and four M6 mounting holes at the base.
Tool (Tool Flange) Uses four M6 thread holes for attaching a tool to the robot. The M6 bolts shall be tightened with 8 Nm, strength class 8.8. For accurate tool repositioning, use a pin in the Ø6 hole provided.
Control Box The Control Box can be hung on a wall or placed on the ground.
Teach Pendant The Teach Pendant is wall mounted or placed onto the Control Box. Verify the cable does not cause tripping hazard. You can buy extra brackets for mounting the Control Box and Teach Pendant.

Warning:

IP rating

Mounting and operating the robot in environments exceeding the recommended IP rating can result in injury.

  • Mount the robot in an environment suited to the IP rating. The robot must not be operated in environments that exceed those corresponding to the IP ratings of the robot (IP54), Teach Pendant (IP54) and Control Box (IP44)

Warning:

Mounting
Unstable mounting can lead to accidents.

  • Always make sure the robot parts are properly and securely mounted and bolted in place.